25mm Dummy Nose Cone for the Lull DLG / Sanding Guide
por Gene Schastnyy en Thingiverse
This nose cone is designed to fit the on the firewall of a Lull DLG / eDLG / F5K kit. If you are not using the recommended 1404 motor with a folding prop, you will have an exposed firewall with the mounting holes for the mentioned motor. So, in case you'd like to keep an option to add the motor...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Gene Schastnyy.
- Categoría
- Repuestos
- Formatos
- SCAD, STL
- Descargas
- 6
- Publicado
Sobre este modelo
This nose cone is designed to fit the on the firewall of a Lull DLG / eDLG / F5K kit. If you are not using the recommended 1404 motor with a folding prop, you will have an exposed firewall with the mounting holes for the mentioned motor. So, in case you'd like to keep an option to add the motor later, or swap between the DLG and F5K setups, just print this cone and mount it with M2 bolts in front of the fuselage. On the other side, it can also serve as a sanding guide for shaping the front part of the fuselage. The mounting "disc" is 3.5mm thick. Print it with 100% infill or at least 4 perimeters to make sure that the mounting holes have enough mateial to hold the M2 mounting bolts.
Descripción original del autor, publicada en Thingiverse.
