2020 Hinge Corner
por Walter Hsiao en MyMiniFactory
Lightweight hinge for connecting two 2020 aluminum extrusions. Designed to fit within the 20mm corner cube. It isn't designed to be load bearing, but should be strong enough to hold the extrusions its attached to. I would try 910 Nylon if you need it to support more weight. There are multiple angles
Licencia
Solo uso personalMyMiniFactory - Credit - Remix - Noncommercial
Licencia de MyMiniFactory: puedes imprimirlo y remezclarlo dando crédito, sin fines comerciales.
Al descargar aceptas respetar la licencia y dar crédito a Walter Hsiao.
Archivos (6)
- 2020 Hinge Corner Files 2020 Hinge 100 Degree V1 2.Stl STL
- 2020 Hinge Corner Files 2020 Hinge 120 Degree V1 2.Stl STL
- 2020 Hinge Corner Files 2020 Hinge 135 Degree V1 2.Stl STL
- 2020 Hinge Corner Files 2020 Hinge 150 Degree V1 2.Stl STL
- 2020 Hinge Corner Files 2020 Hinge 180 Degree V1 2.Stl STL
- 2020 Hinge Corner Files 2020 Hinge 90 Degree V1 2.Stl STL
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 127
- Publicado
Sobre este modelo
Lightweight hinge for connecting two 2020 aluminum extrusions. Designed to fit within the 20mm corner cube. It isn't designed to be load bearing, but should be strong enough to hold the extrusions its attached to. I would try 910 Nylon if you need it to support more weight. There are multiple angles, but I've only tested the 100° version. Print two matching pieces to make a connector.
Parts:
3 - M5x20 Countersunk Socket Screw - the ones that screw into the ends of the tapped aluminum extrusion can be much shorter
2 - M5 Washers - these are inserted from the outside
1 - M5 Locknut - it's easier to tighten if you put the nylon side inside
3 - 8mmx1mm Spacers
2 - 5x10x4 Bearings* - the stack of bearings and spacers goes inside
Printer:
-- Eustathios
Filaments: (full list can be found on thrinter)
-- Atomic Filament Transparent Orange PLA
*affiliate link
Descripción original del autor, publicada en MyMiniFactory.
