12V Splitter Box for LEDs & more

Title says it all. You can make it with 1 Female and 2 Male connectors or vice versa.

Note this is a press-fit model, once assembled and put together you can't disassemble it without breaking it open - designed to be child-proof.

You need to have your offset dialed in tight - if you have too much squish the pieces won't fit together properly.

Note the three red X's in the image - you can put a drop of cyanoacrylate (superglue) where you see the red X's if you like for some added stability. All connectors aren't made to the exact same dimensions, so check the fitment of the connectors before closing the box.

If you want the honeycomb pattern as seen in the photos, use honeycomb infill without bottom layers.

This project is intended for someone with a basic knowledge of 12V wiring. If you are not familiar with wiring electrical components HAVE A QUALIFIED PERSON DO IT FOR YOU! You will need:

18 gauge 12V wire: https://www.amazon.it/dp/B0BCG93BM9?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

12V power supply - note the size of the adapter end: https://www.amazon.it/dp/B0CGD23B6G?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_7&th=1

12V connector adapters: https://www.amazon.it/-/en/dp/B0DX7DW1F9?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1

3 pole 12V switch: https://www.amazon.it/dp/B0BCYXRQSS?ref=ppx_yo2ov_dt_b_fed_asin_title

Dry your filament, eat your vegetables, don't do drugs.