10mm Socket with articulated legs

Meet the elusive 10mm Socket Buddy with articulated legs. He's a cute little socket decoration that you can place almost anywhere. You may want to print several of them, they have a tendency to disappear.

Printing tip: There is a seam obviously, and in the 3mf file it's set to be in the rear of the print, but that only works if the legs are pointed towards the front of the printer. If you rotate anything around, be aware that the seam location may change. Double check your seam before you print and adjust if nessary.

1-29-2024 Added a magnet version! Now your Socket Buddy wont fall off of your toolbox. There is a built in pause in the print profile. When your printer stops, drop in a 12x3mm magnet in the hole on the bottom and hit resume. No glue required, and the magnet will never fall out. The magnets from Bambu work great. A lot of the magnets from amazon are weaker, but may still work. They just might not have the same holding power as the Bambu ones.

I added a larger version (100mm) that has a solid bottom so you can use it as a pencil holder!

Can be scaled up or down too!

And look at this gigantic one printed by another member at a whopping 370%!! 🤯

Check out the other little Buddies as well!

Football Buddy https://makerworld.com/en/models/885717#profileId-840847

Bullet Buddy https://makerworld.com/en/models/860653#profileId-810869

If you are interested in a commercial license for this model or any of my others, please visit my Patreon page. https://www.patreon.com/c/JBCustomDesigns